Subject:
|
Connecting radio module (BiM 418 F)
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 28 Jan 1998 15:02:10 GMT
|
Original-From:
|
Jan-Sipke van der Veen <veenjs@cs.utwente.IHATESPAMnl>
|
Viewed:
|
1969 times
|
| |
| |
Hello all,
I would like to be able to 'drive' my robot using the Handy Board via a radio
link. For this purpose I have bought two transceivers, the Radiometrix BiM 418
F.
How can I connect it to my Handy Board? The wiring is as follows (leaving out
+5V and Ground):
Aerial
|
| ________ Tx select
| |
_____/|_______ Tx data
| \|
|
| _______ Rx select
| |
|__|\_______ Rx data
|/
|_______ Carrier detect
Which pins of the RJ11 connector, digital inputs and SPI do I need for this?
I'm not very good at electronics, so any help would be very much appreciated.
Thanks in advance.
Greetings,
Jan Sipke van der Veen
|
|
Message has 1 Reply:
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|