Subject:
|
Re: Connecting radio module (BiM 418 F)
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 29 Jan 1998 03:44:01 GMT
|
Original-From:
|
Jun Nolasco <nolasco@inx+NoMoreSpam+.net>
|
Reply-To:
|
nolasco@inx.net(IHateSpam)
|
Viewed:
|
5330 times
|
| |
|
|
I have been thinking of getting a pair of those babies. How much did they cost
you?
Thanks.
Jun Nolasco
nolasco@inx.net
Jan-Sipke van der Veen wrote:
> Hello all,
>
> I would like to be able to 'drive' my robot using the Handy Board via a radio
> link. For this purpose I have bought two transceivers, the Radiometrix BiM 418
> F.
>
> How can I connect it to my Handy Board? The wiring is as follows (leaving out
> +5V and Ground):
>
> Aerial
> |
> | ________ Tx select
> | |
> _____/|_______ Tx data
> | \|
> |
> | _______ Rx select
> | |
> |__|\_______ Rx data
> |/
> |_______ Carrier detect
>
> Which pins of the RJ11 connector, digital inputs and SPI do I need for this?
>
> I'm not very good at electronics, so any help would be very much appreciated.
> Thanks in advance.
>
> Greetings,
> Jan Sipke van der Veen
|
|
Message is in Reply To:
 | | Connecting radio module (BiM 418 F)
|
| Hello all, I would like to be able to 'drive' my robot using the Handy Board via a radio link. For this purpose I have bought two transceivers, the Radiometrix BiM 418 F. How can I connect it to my Handy Board? The wiring is as follows (leaving out (...) (29 years ago, 28-Jan-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
