 | | Re: broken motor, how to take apart?
|
|
I have had luck bringing motors of all sizes back to life, by soaking them in WD-40 overnight and then spinning them up with an electric drill. Robb, (...) (URL) (24 years ago, 21-Jan-02, to lugnet.robotics)
|
| |
| | Re: broken motor, how to take apart?
|
|
This general subject has been discussed here before. I'm sure you can search the lugnet archives for more info. However, as my supply of motors has aged, I too have noted that they do tend to seize or at least stiffen up with lack of use. I have (...) (24 years ago, 21-Jan-02, to lugnet.robotics)
|
| |
| | broken motor, how to take apart?
|
|
Not sure if this is the right group...anyway Just got back into Lego robot and rebuilt one of my bots. But one of the motors has become very tight, will just about turn. The motor was left unused for a bout 9 months in a dry room so not sure what (...) (24 years ago, 21-Jan-02, to lugnet.robotics)
|
| |
| | Re: Handyboard Sonar question
|
|
I don't have any connector in the J11 space (middle right edge of the expansion board). All I have are 9 holes in the board that are in the same configuration as the bottom of the sonar module's 9-pin male connector. So if I solder the bottom of the (...) (24 years ago, 21-Jan-02, to lugnet.robotics.handyboard)
|
| |
| | Re: thread class for legOS
|
|
(...) Unless you define a function as a member function, there is no this parameter at all. In the example given, it was not a member function at all (nor should it be). I believe you are thinking of a static member function vs. a non-static member (...) (24 years ago, 21-Jan-02, to lugnet.robotics.rcx.legos)
|
