 | | Re: 2 questions on Polaroid 6500
|
|
Jan, On ribon cable the lead that has the marking is simply there to make it easier to tell what lead is what on the other end. The marked lead usually denotes pin one, but not always. Remember that the drawing is show from a bottom view. Pin 9 is + (...) (24 years ago, 3-Jan-02, to lugnet.robotics.handyboard)
|
| |
| | Re: 0x8000 and main()
|
|
I don't think this is quite it -- IC sets the byte if there's a main fcn. It also sets up some code so that main fcn gets run. Fred (...) (24 years ago, 3-Jan-02, to lugnet.robotics.handyboard)
|
| |
| | Re: 0x8000 and main()
|
|
John, I think it lies in the Pcode, in other words if the pcode sets the 0x8000 to 1 then any program loaded that has main() in it will auto run at startup. If the pcode does NOT set 0x8000 to 1 then no matter what you have loaded as a program it (...) (24 years ago, 3-Jan-02, to lugnet.robotics.handyboard)
|
| |
| | Re: RCX Communication problem... suggestions?
|
|
(...) I've seen similar with the older serial tower. In my case all the diagnostics say the tower is working, but no program written on the lego software will download. The 'instant execute' type functions work, however. Nqc will download happily, (...) (24 years ago, 2-Jan-02, to lugnet.robotics)
|
| |
| | Re: Vision Command ActiveX password
|
|
Hi, you will have to send Kris Wauters an email. He will send you this password per email then. This is out of the documentaition from Kris: ***...*** This ActiveX control is developped for use with the Vision Command Center from the Lego company. (...) (24 years ago, 3-Jan-02, to lugnet.robotics)
|
