 | | Re: NQC, Mac OS X, and the USB IR Tower.
|
|
(...) I assume MacNQC won't work at all because it doesn't include USB tower support yet. Re 9.2.1 - I found the same problem when I moved from 9.1 to 9.2.1. The Lego driver was happy at 9.1 and hung during boot with 9.2.1. It would boot ok if you (...) (24 years ago, 6-Dec-01, to lugnet.robotics)
|
| |
| | Re: Rotation sensor woes
|
|
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi, I have one and just recently purchased another one for one of my projects I am busy working on. I have had no issues at all with it especially not the problems you have described. I would reccomend (...) (24 years ago, 6-Dec-01, to lugnet.robotics)
|
| |
| | Re: Rotation sensor woes
|
|
I have four of these sensors and have not had trouble with them. I suspect that you may have a bad one. -- Bob Fay THE SHOP (URL) Auton" <tim.lugnet@uton.org> wrote in message news:GnwoKL.Atw@lugnet.com... (...) beams (...) intended (...) (24 years ago, 6-Dec-01, to lugnet.robotics)
|
| |
| | Rotation sensor woes
|
|
I'm having problems fitting my Lego Rotation sensor into my models. It doesn't seem to quite fit properly - even the most basic setup of two beams either side held in place by plates on the top or bottom (with 1 plate on top or two plates below the (...) (24 years ago, 5-Dec-01, to lugnet.robotics)
|
| |
| | Re: wireless X10 cameras - any good?
|
|
(...) They suck, don't waste your money. They pretty much require the light of direct sunlight to be able to view anything. Anything dimmer and the picture is so dark you can't see anything. I've been trying to figure out a way to mount a couple of (...) (24 years ago, 6-Dec-01, to lugnet.robotics)
|
