 | | Re: FT vs LEGO pneumatics (was: extensions from hitechnicstuff)
|
|
(...) I would not call anyone a "dumb fool" because they decided to open a set and enjoy it... I was just saying I thought it was a bit ironic that this particular (technic holy grail??) set would be a source... Sets are to be enjoyed. I am gonna (...) (25 years ago, 12-Nov-01, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: Mindstroms 2.0 and NT
|
|
(...) I have installed it with no problem on Win2K. Do you have a full RIS 2.0 with the USB tower? If so, you are probably out of luck for NT. I've heard you can by the serial tower from pitsco-dacta, which should allow you to use NQC on NT fine. (25 years ago, 12-Nov-01, to lugnet.robotics.rcx)
|
| |
 | | Re: FT vs LEGO pneumatics (was: extensions from hitechnicstuff)
|
|
(...) Well, Larry, you can say there's always some dumb fool who has done it. As a matter of fact, I did have a MIB 8680 Arctic Rescue Base set. It's the only thing I have that's got the early pneumatics. So I simply had to open up the box to see (...) (25 years ago, 12-Nov-01, to lugnet.technic, lugnet.robotics)
|
| |
 | | Lego robot at Productronica exhibition in Munich
|
|
Hello! I was at the Productronica exhibition in Munich last week and found this RCX controlled robot there. I will post this once as I am not into robots, I have enough of them at my daily work. See the article on my pages: (URL) see the pictures on (...) (25 years ago, 11-Nov-01, to lugnet.robotics, lugnet.general)
|
| |
 | | Re: IR port
|
|
see the v1.21 parts list in the hardware section, for the following info: re: R4's value. Depending on the variety of the manufacture of the HC132 chip, R4 should be either 3.83K (Digikey 3.83KXBK-ND) or 6.81K (Digikey 6.81KXBK-ND). To test this, (...) (25 years ago, 11-Nov-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: FT vs LEGO pneumatics (was: extensions from hitechnicstuff)
|
|
(...) Found a link to on-line distributors of FT: (URL) (25 years ago, 11-Nov-01, to lugnet.robotics, lugnet.technic)
|
| |
 | | IR port
|
|
Hi $ALL! I just assembled a handyboard. The assembly documentation (hba.pdf) says, that there should be a ~40kHz square wave at pin 2 of U9 (HC04). My frequency counter shows 72 kHz... So I took a new capacitor (682) and a new resistor (3k83) but (...) (25 years ago, 11-Nov-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: hovercraft?
|
|
Hello, my name is Horst, I am from Germany, and I recently bought a used RIS 1.5 (but haven't yet built anything from it). I jumped into this group just recently, this is why I didn't post this reply earlier ... (...) Every electrically powered (...) (25 years ago, 11-Nov-01, to lugnet.robotics)
|
| |
 | | Mindstroms 2.0 and NT
|
|
Hello Everyone: My first post here. Any way I can install the 2.0 cd on a NT laptop. Or is it possible to install just the firmware and then NQC? Any work arounds at all? Thanks JohnC (25 years ago, 11-Nov-01, to lugnet.robotics.rcx)
|
| |
 | | Re: Non Robot uses of the RCX
|
|
"Frank Caggiano" <caggiano@crystal-objects.com> wrote in message news:3B90E72C.520834...cts.com... (...) She was in 4th grade, she used ROBOLAB and the datalogging capabilities, but we moved the raw data to excel for analysis, though it could have (...) (25 years ago, 11-Nov-01, to lugnet.robotics.rcx)
|