 | | Re: Installing Vision Command on Windows 2000?
|
|
"Carlo Ottolina" <kruntz@tiscalinet.it> wrote in message news:GMBqDG.FqC@lugnet.com... (...) nice (...) I download the drivers and installed them, but W2K reports a code 10 problem "device cannot start". I've also tried installing the drivers from (...) (25 years ago, 5-Nov-01, to lugnet.robotics)
|
| |
 | | Problems with ControlLab interface and LabView
|
|
Hi there Is there someone who knows a lot about Dacta ControlLab interface and LabView / Lego Engineer? I've got a problem. When using a standard or a geared Lego 9V motor with the voltage regulator of the train system, I can adjust speed in six (...) (25 years ago, 5-Nov-01, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: Installing Vision Command on Windows 2000?
|
|
"Daniel Crichton" <danielc@helio.co.uk> wrote in message news:GMBnvI.Axt@lugnet.com... (...) says (...) Unfortunately, installing Vision Command on W2K is really a #@#£$£ job. I did it once (manual inst., using W98 machine diffs as an example...), (...) (25 years ago, 5-Nov-01, to lugnet.robotics)
|
| |
 | | Installing Vision Command on Windows 2000?
|
|
Is it possible to install the Vision Command software on Windows 2000? It keeps refusing to install on my SP2 machine, yet there are Windows 2000 drivers on the CD. I can run the setup from the QuickCam folder and it says that there are missing (...) (25 years ago, 5-Nov-01, to lugnet.robotics)
|
| |
 | | Does RL2.5 have array support?
|
|
All -- I'm just getting to grips with RL2.5 (been using NQC prior to this) so apologies that this is a total newbie question. The documentation is, ummmm, skimpy on a number of advanced topics (e.g., LASM support). I'm trying to figure out if (...) (25 years ago, 5-Nov-01, to lugnet.robotics.rcx.robolab)
|