 | | IR devices
|
|
I recently opened up a mouse (the computer kind, not the live kind) and found what I assume to be 2 IR shaft encoders which it uses to translate the direction you are moving the mouse. Is there a way that I could remove them and turn them into shaft (...) (29 years ago, 7-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Shaft Encoders
|
|
(...) We used the line of "S1" optical encoders from US Digital Corp. ((URL) and found them to work superbly. The encoders are light (~.07 lb) and small (~1.7" x 1.3"). The company is a "Value Added Retailer" and adds housings/bearings/whathaveyou (...) (29 years ago, 8-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Burning hot motor driver chips.
|
|
After not doing anything with my HB for a few months, I decided to buy a cheap RC car and use it as a platform. Anyway, I get a car that takes 6 AA batteries because I figure that the main motor is probably 9v (maybe that was a faulty assumption). (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Burning hot motor driver chips.
|
|
Anthony, (...) Yes it sounds like it. (...) It does. The L293D still works after it cools off, doesn't it? (...) I suspect you are going to need more than just two piggy backed L293D. (...) You might have a look at Ben Wirz website, he sells various (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Burning hot motor driver chips.
|
|
(...) sounds reasonable.. which "car" BTW? Some may be using that very same platform and may have some timely advice for you. (...) sounds like overload/overheating cutoff to me. (...) This is from the Handy Board FAQ : <---snip---> It is possible (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|