 | | RCXCC and Scout
|
|
Hi group! Whenever I try to read the values of the Scout with RCXCC it only returns a value of -1. Diagnostics are fine. Is this a known problem or am I doing something wrong? Cheers! Darc. (25 years ago, 15-Jul-01, to lugnet.robotics)
|
| |
 | | 'Erase legOS' keystrokes - Please correct docs
|
|
The 'hold Prgm, and press On-Off' sequence does not work for me. It is necessary to press On-Off *twice* whilst holding Prgm.If someone is unlucky enough not to decide to just press random buttons for a while, the might not figure this out. Great (...) (25 years ago, 14-Jul-01, to lugnet.robotics.rcx.legos)
|
| |
 | | About SensorValueRaw(SENSOR_3) in Scout
|
|
I tried to get raw value of sensors in Scout, the SensorValueRaw(0/1) is ok, I get the raw values of Sensor1 and Sensor2, but I found SensorValueRaw(2) doesn't work, no value is returned. Then I found a example in NQC Guide Version 2.3 r1, it is (...) (25 years ago, 14-Jul-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Toolchain for Cygwin 1.3.2 (latest)
|
|
I have recently built binutils+gcc for the latest cygwin net release. I am investigating the possibility of posting them on the net, but I would like to decrease the file size as much as possible. I have already done 'strip -s' on the .exes, but I (...) (25 years ago, 14-Jul-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Power and Reset
|
|
Hi All, Thanks for the good advice I got. I applied a separate power sypply to the board, to drive the motors and everything seems to go well now. I am not sure if I need to change the L293D for a more powerfull alternative. The chip driving both (...) (25 years ago, 14-Jul-01, to lugnet.robotics.handyboard)
|