To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2906 (+5)
  Re: serial interface
 
[Lisa Meeden] spake unto the ether: (...) Hi Lisa, I wrote the conio.c etc. stuff, but purposely didn't write any kind of command/telemetry protocol like you're suggesting. If a polled serial I/O environment on the HB side is good enough for your (...) (29 years ago, 29-Oct-97, to lugnet.robotics.handyboard)
 
  Re: Initial Download Problems
 
you easily could have blown chips if the vreg was shorted. then you're putting the direct batt voltage into the chips. just about any chip could be blown. sorry for the bad news! i'd try ordering the socketed parts from jameco and swap chips. fred (...) (29 years ago, 30-Oct-97, to lugnet.robotics.handyboard)
 
  Re: serial interface
 
Lisa you could also use the HEXMON40 program you might already be familiar with from the Mini Board. Basically all you have to do is change the motor out and vector location definitions. See the FAQ for the memory map of the Handy Board. (URL) your (...) (29 years ago, 30-Oct-97, to lugnet.robotics.handyboard)
 
  followup: Initial Download Problems
 
just to add a bit, the chips that can be bad if you can't bootstrap are the 6811, the RAM, the 'hc04, and the soldered-down 'hc373. If you have any easy way of swapping first 3 of these 4 these chips, try it. Fred (...) ? (...) co (...) (29 years ago, 30-Oct-97, to lugnet.robotics.handyboard)
 
  Construction problem
 
Initially, I was not able to get the board to config at 0x0c. I got this to work by using DL and some of its command line options. Once I got this to work and set config at 0x0c, then HBDL worked just fine. My new problem is that I can not get the (...) (29 years ago, 30-Oct-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR