 | | Re: Distance sensor for RCX based on Sharp GP2D12
|
| Hi again, nice work (and nice idea). Do you think you can reduce the latency of 300 ms ? Rainer P.S.: And you ask me about that magnet stuff ?!? ;-) Regards Hardwarefreak ! ;-) (...) (26 years ago, 20-Apr-01, to lugnet.robotics)
| | |  | | Distance sensor for RCX based on Sharp GP2D12
|
| Hi all, You will here: (URL) a new interface between Sharp GP2D12 distance sensor and RCX. Simple and inexpensive circuitry, compact design, only one input port used, no external supply needed! As an application example, there is a wall-follower (...) (26 years ago, 20-Apr-01, to lugnet.announce, lugnet.robotics)
| | |  | | Re: LEGO Electro-magnet
|
| Hi Philippe, (...) Hmm, I guess they are NOT protected. (...) Not sure, (I'm not an electrical-engineer please Andreas Peter, help :) ) But, when the coil has a consumption of 9mA at 9V it's 1k. (81mW) So if I undestand it right, you're in parallel (...) (26 years ago, 20-Apr-01, to lugnet.robotics)
| | |  | | Re: was (RCX+PC=Rubik's Cube Solver) RCX & VC
|
| Hi Eric, I disagree in some points. (...) Please notice, that you can build your own vision templates. (URL)The RCX cannot run normal RCX (...) That's not true ! The VC software downloads a little program (myprog.txt) to your RCX. This little (...) (26 years ago, 20-Apr-01, to lugnet.robotics.vc)
| | |  | | Re: LEGO Electro-magnet
|
| Hello Rainer, True! But simplicity sometimes takes a long time to be acheived ;) But there may be some use in flyback and series diodes: Andreas says that his magnet consumes 9mA, below what is available through sensor ports in active mode. So a (...) (26 years ago, 20-Apr-01, to lugnet.robotics)
| |