Announcements : 1048


Announcements / 1048	1047 \| 1049

Subject:	Distance sensor for RCX based on Sharp GP2D12
Newsgroups:	lugnet.announce, lugnet.robotics
Followup-To:	lugnet.robotics
Date:	Fri, 20 Apr 2001 08:55:33 GMT
Highlighted:	(details)
Viewed:	3871 times

Hi all, You will here: http://www.philohome.com/sensors/gp2d12.htm a new interface between Sharp GP2D12 distance sensor and RCX. Simple and inexpensive circuitry, compact design, only one input port used, no external supply needed! As an application example, there is a wall-follower RoverBot with videos at http://www.philohome.com/wallfollower/wallfollower.htm Enjoy ! Philo http://www.philohome.com

Message has 4 Replies:

		Re: Distance sensor for RCX based on Sharp GP2D12
Hi again, nice work (and nice idea). Do you think you can reduce the latency of 300 ms ? Rainer P.S.: And you ask me about that magnet stuff ?!? ;-) Regards Hardwarefreak ! ;-) (...) (24 years ago, 20-Apr-01, to lugnet.robotics)

		Re: Distance sensor for RCX based on Sharp GP2D12
Wow! That's awesome. I might have to take a whack at that one. (24 years ago, 20-Apr-01, to lugnet.robotics)

		Re: Distance sensor for RCX based on Sharp GP2D12
hi Philippe, nice work and some good ideas in it, specially the trick to switch the power off during some time, I'll remember that. And well documented too, keep on building. (...) Stef Mientki email: s.mientki@ids.kun.nl tel: 024 361 3905 fax: 024 (...) (24 years ago, 21-Apr-01, to lugnet.robotics)

		Re: Distance sensor for RCX based on Sharp GP2D12
Very good work, Philippe !!!!!! - Christophe - (24 years ago, 22-Apr-01, to lugnet.robotics)

6 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Active threads in Robotics

	Contact Recovery Nerd for Speedy USDT / BTC Recovery 18 hours ago

Custom Search