 | | Re: legocam as alternative input device
|
|
(...) The only idea I have about that is to write your own virtual serial port to which the VC software points and capture the commands normally send to an RCX. (Is it worth it ?) But if you have the knowledge to do this, you should try the logitech (...) (26 years ago, 1-Apr-01, to lugnet.robotics.vc)
|
| |
 | | Re: Ideas for new sets?
|
|
(...) Pokemon Jürgen (26 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
 | | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) Actually you don't need LegOS, any input set to raw mode with the LEGO firmware will do fine. This is because even in passive mode there is a pull up of 10k to 5V, and in fact the LED is glowing dimly in this mode. Just tried it, I can get raw (...) (26 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
 | | Re: Question about RIS 1.0
|
|
(...) The RIS 1.0 can be run from either 12VAC or 12VDC. In either case an internal bridge rectifier supplies the internal circuitry with the proper polarity. Internal power is supplied through an LM2936M 5V regulator (maximum input of 45V BTW) The (...) (26 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
 | | Re: Question about RIS 1.0
|
|
(...) Transformers do NOT convert AC to DC. They only convert AC to AC. The DC conversion is performed by four diodes in the RIS1.0. Maximum input is rated at 12V AC or DC (the diodes will take care of the polarity for DC inputs) although the (...) (26 years ago, 1-Apr-01, to lugnet.robotics)
|