 | | Re: Ideas for new sets?
|
|
(...) What exists in the real world and what exists in the minds of some marketing personnel is often radically different. The play and educational value of Technic IS still present, but isn't valued as much by the marketing people at Lego. I (...) (26 years ago, 31-Mar-01, to lugnet.robotics)
|
| |
 | | Re: Question about RIS 1.0
|
|
(...) The RCX accepts AC voltage, all it needs to convert to DC is 4 diodes, or a small bridge rectifier. It takes anything from 9-12VAC. Apparently you can do some damage by plugging in DC, as in the long term you will only be passing voltage (...) (26 years ago, 31-Mar-01, to lugnet.robotics)
|
| |
 | | Re: Question about RIS 1.0
|
|
(...) Is that right? Wouldn't the AC adapter be a AC to DC Converter? I have seen the RCX circuit board and I do not remember there being enough room for a transformer built-in to convert the AC signal to DC. Steven B. Combs, MS, CIT Associate (...) (26 years ago, 31-Mar-01, to lugnet.robotics)
|
| |
 | | Re: Question about RIS 1.0
|
|
(...) The RCX uses AC input, not DC. The AC/DC conversion is internal, so what you need is a power adapter that outputs AC. I've heard that you can toast your RCX with an AC/DC adapter as well, so be careful. (26 years ago, 31-Mar-01, to lugnet.robotics)
|
| |
 | | (canceled)
|
|
|
| |
 | | Question about RIS 1.0
|
|
Dear Gang, I recently got the Robotics Invention System 1.0 and I would like to know which would be the positive for the AC adapter, the inside or outside. I have an adapter, but I am not sure how to set the Positive/Negative switch. Thanks, Bryan (...) (26 years ago, 31-Mar-01, to lugnet.robotics)
|
| |
 | | Re: New Palm IR Software to remote control your RCX
|
|
(...) I might have to buy a Palm Pilot now! :) --Todd (26 years ago, 31-Mar-01, to lugnet.robotics.palm)
|
| |
 | | Re: Yet another Q: IR messages
|
|
(...) Hi Tobias I'm not very familiar with NQC events, but if you want to use a blocking function for receiving your message, use parts of the code i posted before. int local_message = 0; int global_message = 0; task main() { //do what you like (...) (26 years ago, 31-Mar-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Yet another Q: IR messages
|
|
If I am understanding what you want correclty (I have never used the RCX-code) only NQC then try this. Assume: RCX2 is sending message # 15 to RCX1. RCX1 is in a waiting state until it gets the message RCX code: . . . While (Message() != 15){ ++i; } (...) (26 years ago, 31-Mar-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: "Speed" of control statments
|
|
Actually, its not a general programming question. Efficiency of something like events is heavily dependent on the operating system (in this case the Lego firmware). Efficiency of "if" vs. "switch" can be very dependent on the compiler and the CPU (...) (26 years ago, 31-Mar-01, to lugnet.robotics.rcx.nqc)
|