 | | Re: Curved Feet
|
|
Is this set still available? If so, does anyone know where it may be purchased? (URL) (26 years ago, 24-Mar-01, to lugnet.robotics)
|
| |
 | | Re: Analogue Control of Pneumatics
|
|
Hi I did some 'research' in this area about three years ago for the control of a pneumatic robot arm. It was quite simple positional control ie position the piston at any point in the cylinders stroke and hold it there. The controller was just a PC (...) (26 years ago, 24-Mar-01, to lugnet.build, lugnet.general, lugnet.technic, lugnet.robotics.rcx)
|
| |
 | | Re: Curved Feet
|
|
After viewing the walder movie, I wonder if it would work with flat feet, and an ankle joint? Gravity would keep the flat foot pointed down when the leg was lifted. - pete. (...) -- Pete Sevcik sevcik@flash.net Techno-stuff Robotics (URL) for FUN ! (26 years ago, 24-Mar-01, to lugnet.robotics)
|
| |
 | | Solar Cell Output in Direct Sunlight
|
|
Well, it finally got sunny here. In direct sunlight, the solar cell seems to put out about 4V, 135mA (26 years ago, 23-Mar-01, to lugnet.robotics, lugnet.dacta)
|
| |
 | | Lego Remote Control - Here's The Scoop
|
|
Hi ! As some of you have noticed, Ms. Jennifer Clark showed off her beautiful new truck model at the Cheshire Legofest recently. The truck was equipped with a prototype radio control system which she has been kind enough to test for me. The (...) (26 years ago, 23-Mar-01, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: Emergency - Half Dead Robot
|
|
Welp, I've fixed the problem. Apparently the inductor at L1 has burnt out. I have no idea how could this have happened beside wear and tear (although the board was pretty new). As others have suggested, replacing the motor chips (starting with U8 (...) (26 years ago, 24-Mar-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: Curved Feet
|
|
(...) Many Znap set have smooth curve part. They can be connected to Technic parts. (26 years ago, 23-Mar-01, to lugnet.robotics)
|
| |
 | | Re: NQCEdit
|
|
Dear two, I like your program very much. I have three suggestions: 1. Give a progress indication when downloading or uploading, if possible. 2. Identify unsaved changes by an asterisk behind the filename in the titlebar. 3. Allow to copy from the (...) (26 years ago, 23-Mar-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Cheshire LEGOFest pictures
|
|
(...) Great! If there's anything I'd like to be able to have instructions to it's probably your models. (and perhaps the MIBO dog will go on the same list...) - David (26 years ago, 23-Mar-01, to lugnet.loc.uk, lugnet.technic, lugnet.robotics)
|
| |
 | | Re: More juice out of the standard motors.
|
|
Yes, I tried it. I don't know how the internals of the RCX work; all I know is I put 12V in, and got 9V out. -- Mark Haye, mhaye(at)tivoli(dot)com "Matthias Jetleb" <jetleb@netcom.ca> wrote in message news:3ab97dfc.301576...net.com... (...) (26 years ago, 23-Mar-01, to lugnet.robotics)
|