To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *27084 (-5)
  Re: Wall transformer for RCX
 
The safest bet is to use a transformer that comes with one of the LEGO train sets. I asked LEGO via email and they recommended using one of these. Here are the specs of of it: Input: 120VAC 60 Hz .12A Output: 12VAC 7 VA (...) (26 years ago, 27-Feb-01, to lugnet.robotics)
 
  Re: Visual NQC 2001 Beta 3 release
 
While I have yet to fully see what Visual NQC 2000 does the major difference between the two is the following. RCXcc IS NOT being supported nor maintained by anyone. Visual NQC 2000 I hope will continue to be maintained when newer versions of NQC (...) (26 years ago, 27-Feb-01, to lugnet.robotics.rcx.nqc)
 
  Re: VC vs Studio cam question
 
Jan Nouza <jan.nouza@vslib.cz> wrote in message news:G9DG0s.HwI@lugnet.com... (...) and (...) cam (...) I haven't seen any noise effects from the Studios camera when close to motors. Personally I think they used the fancy clear shielded cable just (...) (26 years ago, 27-Feb-01, to lugnet.robotics.vc)
 
  Re: Micro-Switches, Mux
 
Knowing the resistor inside the RCX is 10 kOhm, you should use a different resistor for each switch, the first resistor should be 10 kOhm, the second 30 kOhm, third 70 kOhm, fourth 150 kOhm, this will divide the 5V range in nearly evenly spaced (...) (26 years ago, 26-Feb-01, to lugnet.robotics.rcx)
 
  Re: Learning Robolab... !
 
(...) Good question. You're right... they don't download with 2.0. I've asked them about it. I'll let you know when I hear back. (...) That's my touch sensor fork icon (If statement) under Structures | Forks. (...) (26 years ago, 26-Feb-01, to lugnet.robotics.rcx.robolab)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR