 | | Re: Walkers
|
|
Has anyone considered adapting one of the tiny gyros used to stabalize remote control helicoptors ? These work by modifying the pulse stream that controls a standard R/C servo. - pete. (...) -- Pete Sevcik sevcik@flash.net Techno-stuff Robotics (...) (26 years ago, 15-Feb-01, to lugnet.robotics)
|
| |
 | | Re: What are all those lego companies?
|
|
You can get the Control Center for $85.00 US from Pitsco ((URL) but I think Cybermaster is Europe-only. (26 years ago, 16-Feb-01, to lugnet.robotics)
|
| |
 | | Re: bug fixes
|
|
(...) Well, as far as Cygwin on Windoze goes, I'm pretty much a "dummy" user too! Regards, ROSCO (26 years ago, 16-Feb-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Is there a benefit in delegating processing tasks?
|
|
Thanks for the insight, I am sorry that I did not mention the main controller would be a Handyboard (implied though due to the news group). This is still a good point and has given me a lot to think about. The slave controller would continue until (...) (26 years ago, 16-Feb-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: Is there a benefit in delegating processing tasks?
|
|
The advantage of distributed processing is that you can take a sometimes considerable load off the main MCU. Consider a speed regulator: a sensor is needed to continuously monitor the speed at which the wheels are turning and adjustments in motor (...) (26 years ago, 16-Feb-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: Make a goal by the IR port on RCX
|
|
(...) You can't technically overload an input port. Output ports (motors, lights,etc) are a different story. Matthias Jetleb VA3-MWJ (26 years ago, 16-Feb-01, to lugnet.robotics)
|
| |
 | | Re: Make a goal by the IR port on RCX
|
|
A simple on/off sensor can be placed in series or parallel with other on/off sensors however analog sensors cannot. It should be pointed out that if you do group sensors, it becomes impossible to determine which one was actually triggered. This (...) (26 years ago, 16-Feb-01, to lugnet.robotics)
|
| |
 | | Re: Make a goal by the IR port on RCX
|
|
(...) You might try this: stand two mirrors on edge at 90 deg to one another. This creates a corner reflector which will reflect light back in the direction from which it came. Have the robot first search for this reflection and then move toward the (...) (26 years ago, 16-Feb-01, to lugnet.robotics)
|
| |
 | | Re: What are all those lego companies?
|
|
(...) Where does one get CYBERMASTER and CONTROL CENTER anyway? Matthias Jetleb VA3-MWJ (26 years ago, 16-Feb-01, to lugnet.robotics)
|
| |
 | | Re: What are all those lego companies?
|
|
(...) You left out PRIMO (aka BABY). These are aimed specifically at the 0 - 2 age group. They connect with DUPLO on the bottom and a few speciallized pices connect with DUPLO on the top to allow a transition from one product line to another. The (...) (26 years ago, 16-Feb-01, to lugnet.robotics)
|