 | | Re: IC version 3.1
|
|
(...) Yes, the freeware MS-DOS/Windows tools have been known to have problems on some new/fast PCs. It all has to do with old serial drivers. Newton Labs stands behind the commercial product. I recommend that you try it. -Fred -- This message was (...) (29 years ago, 29-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | IC version 3.1
|
|
It has recently come to my attention that IC version 3.1 has been released. I have been using (actually struggling with) the earlier version that came with my purchase of an assembled Handyboard from Gleason Research. Does the new version work (...) (29 years ago, 29-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Manipulate the LCD in assembler
|
|
Folks, I gave it a little more thought, and had some coffee to wake me up. I remember now! Somehow I blew out the D0 line on my LCD and I had to use 4 bit mode from then on since the upper 4 addresses were still fine. I had forgotten that a long (...) (29 years ago, 28-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Manipulate the LCD in assembler
|
|
At 11:28 PM -0400 on 8/26/97, German Gentile wrote: Folks, Ok, I took a look at the code last night. I found simple errors like not initializing the stack, addressing variables in RAM chip when in single chip mode and forgetting to use # for (...) (29 years ago, 28-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | RE: Size Conversions
|
|
These sizes refer to the Unified Thread Standard. A 6-32 thread has 32 threads per inch and a nominal outer diameter of 0.138 inches. There are coarse (UNC) and fine (UNF) series (and some others that are less common), as follows: nom size major dia (...) (29 years ago, 27-Aug-97, to lugnet.robotics.handyboard)
|