To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *26624 (-5)
  Re: Q: Multitasking, and reacting to sensors
 
(...) Jag redan såg den, jag läser lugnet.loc.se :-) (...) No, not if you do everything in sequence. I'd try this first, because it is simpler. (...) Then it is always multitasking, one task on each RCX. (...) You can make one task for each motor of (...) (26 years ago, 6-Feb-01, to lugnet.robotics.rcx.nqc)
 
  Re: Q: Multitasking, and reacting to sensors
 
(...) Ok, I have to admit that I was wrong. But I think most of the time it is the easiest solution to start all the tasks at the beginning and have them run in parallel. And if you want to perform some single action within a task use a (...) (26 years ago, 6-Feb-01, to lugnet.robotics.rcx.nqc)
 
  Re: Pneumatic tubing...
 
(...) I'd pretty much echo what John has said - it is good stuff, with a couple of limitations, the main one being that the inner diameter is too small to allow it to be pushed onto flex system tubes. I've used it on the bucket section of my skid (...) (26 years ago, 6-Feb-01, to lugnet.robotics)
 
  Re: Lght Sensor & Three colors?
 
I'm pretty sure there were no filters involved. This was the basic robot arm that can be built from the 9740(?) Control Lab Starter Set for the Serial Interface Box. She slightly modified it so that there were multiple bins for all of the different (...) (26 years ago, 6-Feb-01, to lugnet.robotics.rcx)
 
  Re: Lght Sensor & Three colors?
 
Ben, did this designer use any filters? Or was this simply the response of the LED and detector in the Light Sensor? (26 years ago, 6-Feb-01, to lugnet.robotics.rcx)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR