 | | Sensors
|
|
Hi, I have a RCX 1.5 and would like to have some information. 1) Is it correct that only port 2 can be use for the light sensor ? 2) And only ports 1 and 3 for the touch-sensors ? Can I use microswitches and some resistors to make an array which i (...) (26 years ago, 28-Jan-01, to lugnet.robotics)
|
| |
 | | Re: Where is this part?
|
|
(...) That's right ! There are 4 of these parts coming with RIS1.5 and RIS2.0 (and some of this special yellow "double connector pegs") (BTW these parts are also avalable wit the vision command camera) (take a look at : (URL) parts and RIS2.0 parts (...) (26 years ago, 28-Jan-01, to lugnet.robotics.rcx)
|
| |
 | | Re: Where is this part?
|
|
Hej Matthias! (...) You can find it at (URL) real life, it's in RIS 1.5 and Vision Command, there are 4 transparently blue ones in the 1.5. There are 3 clear transparent ones in the Vision Command set. (...) Unfortunately not, the RIS 1.5 RCX bricks (...) (26 years ago, 28-Jan-01, to lugnet.robotics.rcx)
|
| |
 | | Re: Two more for the wish list
|
|
A few months ago I built a model of two synchronized metering pumps, one for nitro-goo and one for glycerine-goo. The idea was to have both pumps synchronized. I did it with a differential and a rotation sensor to mark the difference and a (...) (26 years ago, 28-Jan-01, to lugnet.robotics)
|
| |
 | | Re: Two more for the wish list
|
|
(...) Yes - but if you've been following the discussions about dropped counts, you'll know that the standard rotation sensor is pretty inaccurate when you set it up like that. It likes nice *fast* rotation rates. (26 years ago, 28-Jan-01, to lugnet.robotics)
|