 | | Robosports Instructions
|
|
Hello all, I'm Peter. I have RCX 1.0 with mains adapter (from maplins, works great!) and Exploration mars, also Ultimate accsessory set (the remote rocks). I also have many other lego parts, and whish to make some robosports models, I have extra (...) (26 years ago, 3-Jan-01, to lugnet.robotics)
|
| |
 | | Re: Use for Bad Lego Motor
|
|
(...) It should spin easily with just fingertips against the cross-axle. It should continue spinning several rotations on its own inertia from a fast initial spin. (26 years ago, 3-Jan-01, to lugnet.robotics)
|
| |
 | | Re: Use for Bad Lego Motor
|
|
(...) Wait until after you get the new motor from LEGO. Sometimes they WANT the old motor back. I seem to be the king of bad motors. (7 at last count out of 16) All DOA. Lego has asked for about half of them back. I have one motor that spins fine (...) (26 years ago, 3-Jan-01, to lugnet.robotics)
|
| |
 | | Re: Power inlet to RCX 1.5?
|
|
(...) Short answer is yes. Check out this thread at Lugnet: (URL) 2) 130mA. Is that enough? I'm not sure how the RCX works internally, but the (...) Short answer is no. A single motor can draw 100mA. (26 years ago, 3-Jan-01, to lugnet.robotics)
|
| |
 | | Using laptop IR Port instead of the IR Tower
|
|
Hey folks, Has anyone been able to use a Thinkpad IR Port to talk to the RCX? I have been programming the RCX using spirit.ocx. All is well with the IR Tower connected to a serial port. I would like to get rid of the IR tower and use the built-in IR (...) (26 years ago, 2-Jan-01, to lugnet.robotics)
|