 | | Mars expansion set
|
|
Hi all Any feedback on whether the Mars expansion set is worth it? Thanks Mike Bird (26 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
 | | MacNQC Not Recognizing Firmware File
|
|
I'm using MacNQC and when I try to download a firmware file I can't see the file in the "choose file" dialog, although I can plainly see the firmware file in the Finder. Any help would be most appreciated! (26 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
 | | Re: EToys sale
|
|
(...) For sure eToys is in trouble financially... here is a couple of snippets from their SEC form 8-K filing: "As of September 30, 2000, we had an accumulated deficit of $339.9 million. We incurred net losses of $53.4 million for the quarter ended (...) (26 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
 | | MacNQC Not Recognizing Firmware File
|
|
I'm using MacNQC and when I try to download a firmware file I can't see the file in the "choose file" dialog, although I can plainly see the firmware file in the Finder. Any help would be most appreciated! (26 years ago, 29-Dec-00, to lugnet.robotics.rcx)
|
| |
 | | Re: 9V Lamp Source
|
|
(...) Try Train accessory <set:5308> or <set:5310> which may still be available from S@H. There is also a Dacta set of just two lighting bricks for $10, I think. Ben (26 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
 | | Re: VB SDK for RCXs
|
|
The VB SDK is on the LEGO Mindstorms page under the Master Coders SDK area. A word of warning, I looks like 2.0 does not use the OCX that VB uses. You may want to explore the 2.0 software. James J. Trobaugh <james@ngltc.org> wrote in message (...) (26 years ago, 29-Dec-00, to lugnet.robotics.rcx)
|
| |
 | | Re: Lightsensor
|
|
Are you saying that if you shine a bright light into the sensor it only goes up to 47, or is that the reading you get reflected from white paper. You should get 100 when you shine a light into it. Thomas Ruhmann <truhmann@s-direktnet.de> wrote in (...) (26 years ago, 29-Dec-00, to lugnet.robotics.rcx)
|
| |
 | | 9V Lamp Source
|
|
Hello All! Where can I find a good source of the 9V lamps that are available in the Ultimate Accessory set, 3801? The lamp in question is 1x2 white brick with a small bulb. I'd like to get several of these, maybe in other colors (brick, not bulb) if (...) (26 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
 | | Re: Power inlet to RCX 1.5?
|
|
You could use a voltage regulator at the adaptor output. You would not get anything above the rated voltage, but I do not know about lower voltages. Andy (...) (26 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
 | | Re: Power inlet to RCX 1.5?
|
|
Some people already discussed it in the past but I don't remember nobody saying that it was already done. I'm very interested in this matter also. One idea was do use a wire with aligator clips connected to the internal baterry connectors. You may (...) (26 years ago, 29-Dec-00, to lugnet.robotics)
|