 | | Re: Firmdl3 updated
|
|
(...) I wasn't completely sure how much extra data there was in there; I knew it was larger but didn't realize by how much. Regardless, I'll merge in the changes anyway, since I don't want our tree to diverge too much from the One True tree. Luis (...) (26 years ago, 20-Dec-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Firmdl3 updated
|
|
(...) Isn't the actual size of the kernal about half the .srec size? That file contains ascii codes for for hex bytes, a pair of characters would be one byte. Rossz (26 years ago, 20-Dec-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Firmdl3 updated
|
|
(...) Actually, the kernel can hit 21-22K (depending on the compile-time options.) My current legOS.srec sits at 21232 bytes. So, I'm going to do the update. Luis (sort of wishing that Markus had not made so many little changes to firmdl) ---...--- (...) (26 years ago, 20-Dec-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Legos in the news... sort of.
|
|
(...) There is an RCX 1.0 in there too. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 20-Dec-00, to lugnet.robotics)
|
| |
 | | pneumatics
|
|
hi i am in need of 5 small pneumatic pistons does any one know where i can get them ? (26 years ago, 19-Dec-00, to lugnet.robotics)
|
| |
 | | transmission distances
|
|
When I muck about with Exploration Mars software, the RCX doesn't go out of range until it's out of the room. With pbForth, the RCX receives the commands over just as far a range, but can only send its "ok" feedback when it is quite close to the (...) (26 years ago, 19-Dec-00, to lugnet.robotics.rcx.pbforth)
|
| |
 | | Legos in the news... sort of.
|
|
Then don't mention legos in the article but that sure looks like a cybermaster and a DDK in the picture. (URL) (26 years ago, 19-Dec-00, to lugnet.robotics)
|
| |
 | | Re: pBricks & W2K?
|
|
"Matthew Fisher" <matthew.fisher@bigfoot.com> wrote in message news:G5q9vI.EsB@lugnet.com... (...) I did not have any trouble installing it and running it a little, but most of my development happens in nqc now. :) -john (26 years ago, 19-Dec-00, to lugnet.robotics.rcx)
|
| |
 | | Re: What's the cheapest way to get 9V motors?
|
|
You'll want to run though, literally. ZNAP is discontinued and as a result is being dumped everywhere.... (I just got myself two sets for $10,- each and when I went back for more their stock was gone....) Duq "Jeffrey Hazen" (...) (26 years ago, 19-Dec-00, to lugnet.robotics)
|
| |
 | | Re: Tilt Sensors
|
|
I had a couple of thoughts while reading the posting on the bicycle. I am currently working on an adjustable mercury tilt sensor. The size is 2x4, with a height of 1 brick and 2 plates. While it doesn't give the degree of tilt, it will give a closed (...) (26 years ago, 19-Dec-00, to lugnet.robotics)
|