 | | Re: int/float to string routines?%nu
|
|
[Jeff Keyzer] spake unto the ether: (...) Look at my serial I/O routines (Fred has them on the HB ftp/website with the other user-contributed software), specifically the functions in conio.c and serialio.c. I have both float-to-ASCII and (...) (29 years ago, 2-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | int/float to string routines?
|
|
Are there any int/float to string conversion routines available for the handy board? I'm sending data over the HB's serial port to my PC, and I need to be able to send data in string format. (I was originally sending data in its actual byte value, (...) (29 years ago, 2-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | RC bot base
|
|
Hello All, I have just purchased a new TYCO 9.6V Zig Zag car. It seems to have a fairly good base w/treads. I connected it to the handyboard (after gutting it and extending the wires ). Next I gave the motors a test and they both ran way too fast. (...) (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Voltage problem
|
|
Well, further experimentation revealed that the chips are working, but with a quirk: If the the input of the '232 (pin 10) is tied to ground (pin 15), then the output (pin 7 of the '232, or pin 3 of J9) goes to the expected value of ~+10 volts. If, (...) (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | RE: servos?
|
|
The best places are the mail order hobby stores. They have the widest selection of servos and very good prices. The two I recommend are Tower Hobbies (www.towerhobbies.com) and Hobby Shack (www.hobbyshack.com). Either of these sells servos cheaper (...) (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
|