 | | Re: Specification for Adapter for RCX
|
|
I have been using a switchable Radio Shack wall transformer for a while. Make sure its the AC input/AC output style! Set to 9 volts, I used the RcxCC diagnostic panel to view the "battery voltage" at 9.6 volts. That is within spec, because its what (...) (26 years ago, 14-Jun-00, to lugnet.robotics)
|
| |
 | | Re: Specification for Adapter for RCX
|
|
(...) I stand corrected. (26 years ago, 14-Jun-00, to lugnet.robotics)
|
| |
 | | Re: Specification for Adapter for RCX
|
|
Matthew Miller wrote in message ... (...) Sure they do, go to: (URL) Spare Parts, Tools, & Resources - LEGO Dacta Spare Parts - Miscellaneous: Adapter, Identifier: W979833 Allows the RCX to operate from a main power supply rather than from (...) (26 years ago, 14-Jun-00, to lugnet.robotics)
|
| |
 | | Re: Specification for Adapter for RCX
|
|
(...) I don't think Lego makes one. (26 years ago, 14-Jun-00, to lugnet.robotics)
|
| |
 | | Specification for Adapter for RCX
|
|
Hi, I am looking for the EXACT specification for Lego's wall-wart for the RCX. What is its exact power ratings etc. etc? So, if anyone has the Lego wall-wart, can you read the specs out for me. Thanks Ram (26 years ago, 14-Jun-00, to lugnet.robotics)
|
| |
 | | Re: LNP Question
|
|
Hello Colin, (...) (26 years ago, 14-Jun-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: HB Memory map
|
|
Device Location Notes ===...=== 6811 internal $0000-$00ff Built-in RAM (A1 chip) $0000-$01ff (E1 chip) ---...--- 6811 control $1000-$103f Built-in registers ---...--- Expansion I/O $4000-$4fff Memory reads in this range enable the Y1 latch selector, (...) (26 years ago, 14-Jun-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: LNP Question
|
|
"Colin Ryan" <colin.ryan@cs.tcd.ie> ha scritto nel messaggio news:394758BE.3DEA88....tcd.ie... (...) I'm working to a porting of lnpd for Win32, but it's not finished yet... Bye, Paolo. --- Indecision is the key to flexibility. (26 years ago, 14-Jun-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Interfacing BASIC Stamp and Lego?
|
|
In a flee market, I stumbled upon an Swedish electronics magazine with Lego on its cover. Of course, I had to buy it. :) The article's header read: "LightFinder - Controlling Robots using BASIC Stamp". The article is of course in Swedish but if (...) (26 years ago, 14-Jun-00, to lugnet.robotics)
|
| |
 | | Re: Motors spinning at startup
|
|
The problem is the same with LEGO-gear-motors. Even worse, the post says "... put a wire to the can ..." but how can you do this with a plastic device? Any help appreciated. Dirk (26 years ago, 14-Jun-00, to lugnet.robotics.handyboard)
|