To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2161 (+5)
  Re: Soldering
 
(...) experience >at all with soldering. (...) become more >adept at this sort of stuff. And what type of solder should I use? Shane is right, you'll find using very thin solder works much better. Along with a fine tip, you'll want to use a low (...) (29 years ago, 18-May-97, to lugnet.robotics.handyboard)
 
  Re: Soldering (fwd)
 
Often novices miss the single most fundamental point about soldering: you don't use the iron to melt the solder (99% of the time) -- you heat the component leads and let them melt the solder. To initially transfer heat effectively to the leads, a (...) (29 years ago, 18-May-97, to lugnet.robotics.handyboard)
 
  (no subject)
 
Another note on soldering.. Heat control is VERY important.. Not so much being able to adjust the heat, as having a temperature-controlled iron. The "cheaper" irons get hotter or colder with the load (speed of soldering) as well as the room (...) (29 years ago, 19-May-97, to lugnet.robotics.handyboard)
 
  Strange HB problems
 
Over the past two days I have had two problems with my HB that I can't explain. Maybe you you can help. 1. I wrote a simple program to test out my motors that consists of the motor, sleep, and beep commands. Once in a while I get an error back while (...) (29 years ago, 19-May-97, to lugnet.robotics.handyboard)
 
  Re: Vector 2x compass
 
A mistake has been found on the V2X schematic, the M/S pin on the compass needs to be grounded. I don't know what it is, everytime I publish something, I make a mistake. (29 years ago, 19-May-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR