 | | u14
|
|
I had trouble finding u14(LM 2931Z-5.0). I thought I might be able to use the 78LO5A that was suggested as a replacement on the mini board. When I try to test the voltage on pin 28 of U2 as described in part 2 of the assembly manual I get 6.3 volts. (...) (30 years ago, 28-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR concept
|
|
(...) [Digitize the output from an IR LED with and without a signal present to achieve some common mode noise rejection.] This type of system is susceptible to being 'blinded' by high intensity IR sources (try it outside :-) I used a similar (...) (30 years ago, 29-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Sonar Transducer Multiplexor
|
|
In your BMP circuit diagram that you posted recently, why did you use an open collector to feed the base of the transistor? Would it work if you connected the digital signal directly to the base? ---...--- ericson mar Master of Engineering Candidate (...) (30 years ago, 29-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Sonar Transducer Multiplexor
|
|
(...) The OC is simply a protective buffer to the SPI pins. When the SPI feeds a low with a pullup resistor it must be able to sink the current drawn by the resistor. I read some of the docs on the SPI pinouts and ("M68HC11 Reference Manual" Serial (...) (30 years ago, 29-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | re: IR frequency (fwd)
|
|
(...) signals at exactly 38KHz? somebody had suggested using an oscilloscope..but how do i go about it? (30 years ago, 29-Mar-97, to lugnet.robotics.handyboard)
|