Subject:
|
re: IR frequency (fwd)
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 29 Mar 1997 19:11:17 GMT
|
Original-From:
|
Sriram Tirunellayi <sriram@ds5500.cemr.=IHateSpam=wvu.edu>
|
Viewed:
|
1517 times
|
| |
| |
>
> how do i find out if the IR transmitter (on handy board) is sending
signals at exactly 38KHz?
somebody had suggested using an oscilloscope..but how do i go about
it?
|
|
Message has 1 Reply: | | re: IR frequency (fwd)
|
| Connect the ground from the oscilloscope to the HB ground (anyone). Connect the V from the oscilloscope to the + end of the LED driver (or the annode of the LED if it's connected). Adjust the oscilloscope until you get a visible square wave (...) (27 years ago, 30-Mar-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|