 | | Re: Motors & handyboard
|
| (...) This is also excellent advice. On one R/C car I had, I ended up having to simulate the signal input to the controller because the h-bridge was so screwy but it does save you from having to build your own. On a related note, Radio Shack sells (...) (30 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | |  | | Digit outputs....
|
| I've tried to program the digital outputs from the SPI header J6 on the HB with no success. I pump the values into the HB as per instruction form the FAQ note and measure the 4 outputs. No high/low, just some sort of oscillation. What could be my (...) (30 years ago, 20-Feb-97, to lugnet.robotics.handyboard)
| | |  | | Re: Digit outputs....
|
| Rather than trying to figure out the hex for the bits, I use the IC binaray number format, "0b". I set the bits using a binary mask, for example, to set the MOSI pin high, I use: bit_set(0x1008, 0b00001000) then to set the MOSI pin low, I use: (...) (30 years ago, 20-Feb-97, to lugnet.robotics.handyboard)
| | |  | | SPI Routines in IC
|
| Anybody have any routines or know of any published information for using the SPI with IC for: ...use with Dallas Semi's serial real time clock - DS1202 ...use with 12 Bit serial A/D - LT1298 ...use with Dallas semi's Thermomerter - DS1620 Thanks a (...) (30 years ago, 21-Feb-97, to lugnet.robotics.handyboard)
| | |  | | motor drivers
|
| Hi all, I am running some motors from a Mini Board and I want to up the current output of the board. I have noticed that the motor drivers on the MB are the L293 chips just like the Handy Board. Now if the 1 Amp motor chips that many Handy Board (...) (30 years ago, 21-Feb-97, to lugnet.robotics.handyboard)
| |