 | | Re: multiplexed touch sensors [was: Re ideas for a RIS 2.0]
|
|
Some corrections to my last post: (...) should be: turning LEFT when greater than 1000, the robot kept its left feeler against (...) should be: spent most of the time between 101 and 110. (Once TRACKING the wall, I never *saw* (...) should be: (...) (27 years ago, 27-Aug-99, to lugnet.robotics)
|
| |
 | | MacNQC for 64k Macs
|
|
Hallo Dave, for playing and programming Lego RCX I would like to use my older Macs, a PowerBook 190cs and Macintosh IIsi. So my children could use my 9500 while I am using Legos with the smaller ones. Also there is no chance to get ROBOLAB from Lego (...) (27 years ago, 27-Aug-99, to lugnet.robotics)
|
| |
 | | Re: Touch Sensor as a Switch
|
|
(...) Connecting N touch sensors in parallel requires N pieces of wire, while doing so in series requires N+1 pieces of wire. See? It's not that bad. Here is my experimenting results of connecting the three Cyber Master touch sensors to RCX in (...) (27 years ago, 27-Aug-99, to lugnet.robotics)
|
| |
 | | motor speed control
|
|
I have added another web page, this time discussing a way to control the speed of a motor that actually gives you a wide range of speeds. (URL) are no pictures and I had to re-type the NQC code by hand, but the method works fine; I tried it last (...) (27 years ago, 27-Aug-99, to lugnet.robotics)
|
| |
 | | Re: MacNQC for 64k Macs
|
|
I should add a link to the docs from the MacNQC page - sorry. The general NQC 2.0 beta test page has some documentation as well as a MPW tool version of NQC that should run on 68k macs: (URL) docs are very brief - mostly just a list of differences (...) (27 years ago, 27-Aug-99, to lugnet.robotics)
|