 | | Re: LCD screen
|
| Garth The contrast of the LCD can be adjusted. The third pin from the left side of the LCD, labeled VR on the HB is the contrast adjustment. You can cut this pin from the male header than connects to the HB. Solder a small trimmer pot with the wiper (...) (30 years ago, 22-Jan-97, to lugnet.robotics.handyboard)
| | |  | | Re: LCD screen
|
| (...) I ended up with a display that did this very thing (A Rolm display I think), and what I did was to cut the contrast lead coming out of the LED connector, and then solder a 20k pot to the GND, +5V, and Contrast leads so that I could vary the (...) (30 years ago, 22-Jan-97, to lugnet.robotics.handyboard)
| | |  | | RE: dual servo update
|
| Mike writes : (...) The limit is specified by the product manufacturer. Futaba servos don't guarantee they will hold unless they see a pulse every 20mS. The Tower Hobbies servos are a bit more lenient. If you have the servo manufacturers data sheet, (...) (30 years ago, 22-Jan-97, to lugnet.robotics.handyboard)
| | |  | | bipolar steppers
|
| Was wondering if anyone has an alternate solution to stepping a bipolar stepper? Currently.... I'm using an H-Bridge (driver if you will) SAA1042 (by Motorla) which is then getting its pulses from 1 of the motor outs on the Handy Board. The (...) (30 years ago, 23-Jan-97, to lugnet.robotics.handyboard)
| | |  | | IC loop
|
| Hope someone can help, I have just written my first code for my bot. All I have done so far is make my bot go forward in about a 4 foot square area. I am now wanting to put a loop in the code so that it will continue for a certain length of time or (...) (30 years ago, 23-Jan-97, to lugnet.robotics.handyboard)
| |