To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1261 (+5)
  RE: LM629 and "quadriture incremental" encoders
 
The last time I priced these chips they were $249.00 each qty 1. (a bit expensive for my robots, but I've used them and they are cool) --Chuck ---...--- From: James Lewis[SMTP:jlewis@nomadics.com] Sent: Wednesday, January 15, 1997 5:10 PM To: (...) (30 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
 
  Re: unsubscribe
 
Please unsubscribe "vie100@psu.edu" from the mailing list. (...) (30 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
 
  Re: dual servos
 
There may be two separable issues in your experiment: 1. "twitching" when the control value isn't changing. this should not happen. 2. twitching because of flakiness in the pot reading. this would not surprise me at all. if the A to D reading on the (...) (30 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
 
  Re: IR wall detection
 
Keith, Try an LM567. It's a tone decoder with PLL and VCO. Basically set the internal freq. of the 567 any where between .01 Hz up to I think 500 kHz. Feed a signal into the 567 and if the freq's match up, the 567's output goes low. I've been (...) (30 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
 
  Re: LM629 and "quadriture incremental" encoders
 
James, That's probalby my post you read. I'm still working on hooking 'em up. I'm gonna use two 629's and two 18200 H-bridges. The 629 uses encoders simmilar to the ones in mobile robots. The quadrature encoder has two signals that are 90 degrees (...) (30 years ago, 16-Jan-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR