 | | Re: Using RC cars for robot
|
|
(...) We have successfully integrated a Traxxas RC car with the Handy Board. The vehicle uses a standard servo for steering and an electronic speed control (same behavior as a servo.) Since the HB can control 2 servos this works well. In this case (...) (30 years ago, 2-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | pcode downloading
|
|
Happy New Year! I'm putting together a HandyBoard and am stuck at the point where pcode_hd.s19 is downloaded. Some details: Have a chip labled SIPEX SP232ACP as a substitute(?) for MAX232. During downloading using DLM the board syncs OK but (...) (30 years ago, 2-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Problem Downloading Pcode!!!!
|
|
Hi, I'm really stuck. I got a facory fresh HB, instead of a Motorola it had a Toshiba C11W chip. When dowloading pcode_hb.s19 IC Win 95 says "CONFIG register required resetting. Please place in download mode again." Help, my scince project is due in (...) (30 years ago, 2-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Coparison of Sensors
|
|
Hi, I know this is probably a stupid question to you, but I wrote a program to compare sensors. But it doesn't seem to work. Can anyone help?? Here it is (30 years ago, 2-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: pcode downloading
|
|
Here is the relevant part of the test instructions: Finally, the MAX232's ability to transmit data to the host computer is tested. Again using pin 7 of J9 as a ground reference, measure the voltage at pin 3 of J9. This is the MAX232's serial output. (...) (30 years ago, 3-Jan-97, to lugnet.robotics.handyboard)
|