To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *11431 (+5)
  Measuring motors current
 
Hi, I'm using for my base 12 v geared motors ,without load, each one drives less than 100 mA, but when stalled, the current grow to 500 mA, wich is to close to the 600 mA of L293 chips, i do not need more current, but i want to protect the L293 from (...) (28 years ago, 10-May-99, to lugnet.robotics.handyboard)
 
  Re: charger
 
Hi all: The problem with using a wall wart that is NOT 12 V @ 500 mA is this: most wall warts are _not_ regulated, and they have a fairly high internal impedance. If there is no load on a "12 V" unit, the output voltage will likely be at least 18 V, (...) (28 years ago, 10-May-99, to lugnet.robotics.handyboard)
 
  Re: Ir transmission
 
(...) I can't get EMIT to work, in NQC I do this: SendMessage(255); // Flash Sleep(3); ThisRaw = RAW_LIGHT; and the raw light sensor reading has big spikes for IR reflections. but: [ HEX ] FF EMIT 30 msWait RawLight LIGHT? does not, I think that (...) (28 years ago, 10-May-99, to lugnet.robotics.rcx.pbforth)
 
  Re: RCX and Java
 
(...) rotation (...) No, java was picked because the company did not wan't to use C++ as it had some bad experience with projects taking way too long to complete. It had used Visual basic (yieek) before but it tended to be slow and the code was not (...) (28 years ago, 10-May-99, to lugnet.robotics)
 
  Re: charger
 
the main reason this doesn't work is the 1a supply produces too high a voltage at the actual current being drawn, resulting too high a charge rate. technically, it will work in NORMAL charge mode, but you'll be charging the battery too fast, (...) (28 years ago, 10-May-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR