To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *10786 (+10)
  Re: Downloading Firmware to RCX
 
In article <F4wwLv.DwC@lugnet.com>, Kekoa Proudfoot <lugnet.robotics@lugnet.com> writes (...) way (...) of (...) [snip excellent description] At long last I have done it! While recovering from an illness I have managed to get it going - thanks for (...) (28 years ago, 14-Apr-99, to lugnet.robotics)
 
  Re: legOS Network Protocol
 
(...) Sounds good. Does it provide a stream interface or datagrams only? My faulty memory suggests that it might be the latter. If the network implementation supports packet reassembly (packets larger than MTU), there may not be a need for a stream (...) (28 years ago, 14-Apr-99, to lugnet.robotics.rcx.legos)
 
  Re: motor drivers
 
Try Wriz electronics. I think their internet address is www.wriz.com (...) (28 years ago, 14-Apr-99, to lugnet.robotics.handyboard)
 
  Re: how to
 
Does anyone know what it takes to become an "official Handy Board distributor" of assembled boards? There are only two, and there ought to be three! Thanks, Gary Livick (URL) (28 years ago, 14-Apr-99, to lugnet.robotics.handyboard)
 
  Re: motor drivers
 
-->Try Wriz electronics. I think their internet address is www.wriz.com Actually, it's Wirz Electronics (URL) you can check out (URL) this helps. --kam (URL) -->On Wed, 14 Apr 1999, Chen Yung Hsu wrote: --> -->> Hi! i'm looking for places that sell (...) (28 years ago, 14-Apr-99, to lugnet.robotics.handyboard)
 
  Re: how to
 
Gary, Write direct to Fred Martin. By the way there are three! We downunder at robot-Oz do distribute unassembled and assembled boards in the Australia/Oceania area using Patrick Hui's boards. We just haven't made it onto the Vendor page yet. Will (...) (28 years ago, 14-Apr-99, to lugnet.robotics.handyboard)
 
  Re: how to
 
The licensing info is at : (URL) you can do what you want with it, invluding selling it, as long as you keep the copyright info intact, and acknowledge Fred Martin and the MIT Media Lab as the creators. Keith Disclaimer: I'm not a lawyer and the (...) (28 years ago, 14-Apr-99, to lugnet.robotics.handyboard)
 
  Re: motor drivers
 
might have better luck with www.wirz.com ---...--- | From: Naser A. Ameen <naa6195@silver.sdsmt.edu> | To: Chen Yung Hsu <hsu3@cooper.edu> | Cc: Handyboard@media.mit.edu | Subject: Re: motor drivers | Date: Wednesday, April 14, 1999 3:46 PM | | Try (...) (28 years ago, 15-Apr-99, to lugnet.robotics.handyboard)
 
  Re: preventing IR tower shutdown
 
(...) In VB you would probably want to put a DoEvents in such a tight loop. -- Did you check the web site first?: (URL) (28 years ago, 15-Apr-99, to lugnet.robotics)
 
  What good is the small gear motor?
 
I recently bought the small red gear motor to use in my panoramic camera mount. The purpose of the motor was to rotate a hammer to strike the camera shutter button after the camera had rotated. I wanted to use the small motor because I found that (...) (28 years ago, 15-Apr-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR