To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *10671 (+5)
  Power drain of the motors
 
Is there any way to measure the power drain of a running motor? The reason I ask is that I want to detect when the motor has stalled. I use nqc to program the brick. thanks -chris -- Did you check the web site first?: (URL) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  Re: Power drain of the motors
 
(...) The CyberMaster can! ;-) Maybe there's some way you can connect one input to the motor output? Laurentino Martins [mailto:lau@mail.telepac.pt] [(URL) you check the web site first?: (URL) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  GCC/HC11 small patch
 
I contacted the original person who did the HC11 port to gcc (Otto Lind), and he pointed me to a patch for it. If you're using gcc-2.8.1 with the HC11 patches in it, you may want to try this: At line 502 of config/m6811/m6811.c, change from: { (...) (28 years ago, 9-Apr-99, to lugnet.robotics.handyboard)
 
  Re: Increasing current output to motors on HandyBoard
 
Haven't actually tried it, but I was thinking of the same sort of thing. Use a FET for PWM and a DPDT relay for direction. practically speaking, if you only switched the relay when the FET was off, no power transition, etc.... If your 'bot moves (...) (28 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
 
  Re: Increasing current output to motors on HandyBoard
 
Howdy, My original suggestion was to use *solid state* relays. They don't have any contacts. I use them plugged right into my Rug Warrior board at the motor output ports (would work the same on my Handy Board, but I have it on a smaller base, and (...) (28 years ago, 10-Apr-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR