Subject:
|
Re: Modifying the 6272c01 Electric RC Race Buggy Battery Receiver Unit with Auxiliary Output
|
Newsgroups:
|
lugnet.parts.mod
|
Date:
|
Thu, 19 May 2005 18:11:33 GMT
|
Viewed:
|
7865 times
|
| |
|
|
In lugnet.parts.mod, Tim David wrote:
| |
| |
The “large thing” looks like some kind of coil+ferrite core to me.
AFAIK That is really part of the tuned circuit for the radio
reception.
|
That sounds plausible, although I’m not an electronics expert it has that look
to me. Ideally it would be good to unsolder it and place it on the other side
of the board but that probably won’t be possible. If it was a coil+ferrite
core would extra the length of extension wires effect the tuning?
|
That is definatly a tuning coil. You may be able to swap the coil to the
opposite side of the board, but adding long wire would be a vey bad idea. If you
swap it, orientation is very important. You will need to mark it’s oreintation
on the main board and then remove it. While removed, test continuiety between
the wire leads of the coil. If there are 2 pair of connected leads, you should
be fine. Just make sure each pair of leads is mated to the correct hole pairs.
Be careful, these things are easy to destroy.
|
|
Message has 1 Reply:
Message is in Reply To:
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
