Subject:
|
Re: need to make a 15 degree angle
|
Newsgroups:
|
lugnet.parts
|
Date:
|
Wed, 1 Oct 2008 01:42:01 GMT
|
Viewed:
|
12487 times
|
| |
|
|
In lugnet.parts, Nick Kappatos wrote:
> In lugnet.parts, Timothy Gould wrote:
> > In lugnet.parts, Sam Pagel wrote:
> > > anyone know of a part or combination of parts that would make a 15 degree angle,
> > > similar to the way 30365 and 30364 (locking hinge bricks) work. I would use
> > > those but they only stop at every 22.5 degrees. It wouldn't have to be a
> > > compact part(s) either, i have lots of room to work with, just have no idea how
> > > to achieve the angle.
> >
> > Brick hinge? Or the older style finger hinges.
> >
> > Tim
>
>
> Some combination of Technic Angle Connector #3 and 1x2 Technic bricks with holes
> (or axle holes) may do it, though I couldn't find a protractor:
>
> http://www.peeron.com/inv/parts/32016
>
>
> -nick
Yeah, never mind - that's 30 degrees.
BOOOOOO.
|
|
Message has 1 Reply:
 | | Re: need to make a 15 degree angle
|
| (...) If so, 45-30=15, and I know there are plenty of ways of make a 45 degree angle. Just arrange the 30 degree connector against a 45 degree connector, and presto! 15 degrees. DaveE (18 years ago, 1-Oct-08, to lugnet.parts)
|
Message is in Reply To:
| | Re: need to make a 15 degree angle
|
| (...) Some combination of Technic Angle Connector #3 and 1x2 Technic bricks with holes (or axle holes) may do it, though I couldn't find a protractor: (URL) (18 years ago, 1-Oct-08, to lugnet.parts)
|
12 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
