| | Re: 3T Board Change Suggestion
|
|
(...) Well, there was one robot that didn't have this problem too much. The one picture of a cube mysteriously perched on edge next to a board is not doctored - *somehow* my robot just clipped the cube as it left the board, rolling it out of the (...) (19 years ago, 8-Jan-06, to lugnet.org.us.laflrc)
|
|
| | 3T Board Change Suggestion
|
|
In the posts regarding the get together for 3T, it was mentioned that all the robots had a few issues getting cubes to sit flat in the holes. I have spent a lot of effort to tweak my drop locating method so that it hits the holes perfectly. What I (...) (19 years ago, 7-Jan-06, to lugnet.org.us.laflrc)
|
|
| | Re: 3T
|
|
(...) My robot also basically rests on a 32x32 plate...I have an extension off the back more for some stability than anything else. (...) Good news - I also have a low riding front end and can help Steve outflank the Vikings at the next get (...) (19 years ago, 7-Jan-06, to lugnet.org.us.laflrc)
|
|
| | Re: Creating a GBC for a train layout
|
|
(...) Well, if the GMLTC 8-wide trains were involved, it would definitely be "mutilate, in a spectacular crash"... (URL) Here's one of my 8-wide locos> But, I'd suggest just go with what works for you. If an 8-wide train doesn't work, don't run (...) (19 years ago, 6-Jan-06, to lugnet.org.us.laflrc, lugnet.trains, FTX)
|
|
| | Re: Creating a GBC for a train layout
|
|
In lugnet.org.us.laflrc, Timothy Gould wrote: -SNIP- (...) Here's a link to the rendering of the train car we're asking about. (URL) The blue 2x2 round bricks slung between the train wheel sets is what we're concerned about. In this 6-wide train (...) (19 years ago, 6-Jan-06, to lugnet.org.us.laflrc, lugnet.trains)
|