 | | Re: Plexi ... again
|
|
(...) So does this mean we have a B1 and a B2 kinda like J2/J3?:-) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.org.us.michlug)
|
| |
| | Re: Reed sensors are not working very well (or too well?)
|
|
(...) The train car will still have no problems clearing as long as my "inside-1" (1 fulll stud clearance beyond the end of railroad tie on inside corners). On a straight, it doesn't even come to the end of the tie. I'm not sure where you're placing (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| |
| | Re: Reed sensors are not working very well (or too well?)
|
|
(...) Robin, I've created a building hiding the sensor. (URL) here is the side showing the sensor. (URL) it's height, is this good for you? My program will be created on this building being 1 stud away away from the track base. This gives 10 stud (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| |
| | Re: Reed sensors are not working very well (or too well?)
|
|
(...) Our widest trains are 8 studs wide right? So that puts it to the end of the track. I'll make a little building with the switch recessed. How high is it from the table to where the center of the switch is? I'll need this to setup the height's. (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc)
|
| |
| | Re: Reed sensors are not working very well (or too well?)
|
|
(...) I had not know of anyone using reed switches with lego before so I don't have any links to info, but I used a standard reed switch, encased in glass. NO (Normally Open). There was a 20 mm and a 25 mm I believe. (...) I've created a trolley (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
