 | | Re: NMRA2003 Friday install —Derek Raycraft
|
| | | (...) I can do that. Wasn't sure what needed to be done, was going to ask later. Just figured that was a convenient place to put one. (...) Ok, lets just say the outside loop is the master control loop and all other RCXs will key off this loop. (...) (21 years ago, 14-Jul-03, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: NMRA2003 Friday install —Calum Tsang
|
| | | | (...) I can bring my PalmVx which functions as a remote if needed. (...) I can bring them back as well, no problem. What I'll do is this. We'll set up on Friday, and I'll bring out my major conponents (red station, yellow freight station) then (...) (21 years ago, 14-Jul-03, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: NMRA2003 Friday install —David Koudys
|
| | | | | (...) sounds good (...) Had? Have! I could open a Commodore museum--Pet (4032x2, 8032-just the motherboard) Vic, 64, 128, SX64 and many many peripherals--4040, 8250 dd for the Pets, 1541x4, 1571x2, 1581x1 drives for the 64, et al, modems, joysticks, (...) (21 years ago, 14-Jul-03, to lugnet.org.ca.rtltoronto)
|
| | | | | |
| | | | | | | Re: NMRA2003 Friday install —Calum Tsang
|
| | | | | | (...) I started with an Apple II Plus clone. Had a 2001N32 PET with a 2031LP, probably a 64 or two (or several in my garage) and requisite 1541, 1541C and 1541-II drives. Destroyed a 1571 trying to convert it into an A1020 Amiga drive. Had every (...) (21 years ago, 14-Jul-03, to lugnet.org.ca.rtltoronto)
|
| | | | | | |
| | | | | | Re: NMRA2003 Friday install —Mario DeFacendis
|
| | | | (...) I never owned any Commodore h/w, but I did lug a friend's machine into work once to troubleshoot. Yep, I watched C64 bus cycles on a $20000 logic analyzer... what's wrong with this picture?? That was waaaay back in the day when I used to play (...) (21 years ago, 15-Jul-03, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: NMRA2003 Friday install —Calum Tsang
|
| | | | (...) You mean like the time we used the 300Mhz Tektronix scope to watch the DCC project? Or the FPGA/PAL/GAL/PIC machine to program the PALs for the DCC encoder? Or the time we misappropriated a workstation to program ProjectX (or for that matter, (...) (21 years ago, 16-Jul-03, to lugnet.org.ca.rtltoronto)
|
| | | | |
