 | | Re: Train width clearance for wide turns, etc. —Derek Raycraft
|
| | | (...) Sorry I didn't get a chance to dig my cars out last night. I'll do it tonight and post bogie locations and lenghts for tomorrow. The good thing with the sweeping turns is the cars won't stick out as much. Derek (22 years ago, 30-Jul-02, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: Train width clearance for wide turns, etc. —Derek Raycraft
|
| | | | Ok I figured out the size of the Go Train last night. Passenger Cars: Length: 50 8 wide length: 48 Bogie plate pin sits between the 6 and 7th studs from the ends. 38 studs between bogie plate pins. Engine: Length: 45 8 wide length: 44 Bogie plate (...) (22 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: Train width clearance for wide turns, etc. —Derek Raycraft
|
| | | | | (...) That should be between the 10 and 11th studs from the front. Derek (22 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto)
|
| | | | | |
| | | | | | Re: Train width clearance for wide turns, etc. —Jeff Elliott
|
| | | | I assume that all the bogies are 8 long and rotate at the centre? That is, each consists of 2 3x4 new wheelsets with a 2-stud gap between? That's what it looked like in the photos, anyway. Jeff E (...) (22 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: Train width clearance for wide turns, etc. —Derek Raycraft
|
| | | | The passenger car bogies are 8 long with the pin in the middle. The Engine has one motor and one dumbie motor which has the same geometry as a motor. The actual size of the bogies shouldn't make a difference provided the pin is centered between the (...) (22 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto)
|
| | | | |
