 | | Re: Train 3 Height and Width
|
|
(...) Here's what I did: I have stacked 3 modules. The North and South face of the stack has two vertical 1x2s bolted to each module, and a diagonal brace bolted to the top and bottom module, making an "N" shape on the north and south face. This (...) (23 years ago, 8-Jan-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Train 3 Height and Width
|
|
"Jeff Elliott" <jeffe@telepres.com> wrote in message news:3C3B56B3.83ACCD...res.com... (...) That sound like an idea.... I will probably stack mine that way... (...) I dont mind doing it Jeff, I will have to ensure that the module-stack® will (...) (23 years ago, 8-Jan-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Train 3 Height and Width
|
|
"Jeff Van Winden" <Jvwinden@sympatico.ca> wrote in message news:Gpn8A6.JMC@lugnet.com... (...) will (...) Jeff, the clearence of my car is 29 - 30 inches..... How am i going to stack 3 modules in 30 inches......... DOH!!! Jeff VW (...) (23 years ago, 10-Jan-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Train 3 Height and Width
|
|
(...) well, think of it like this: Say you build your frames at 24 inches. That means 11 inches between the three holes. Put your taller modules as the bottom and middle, and your lowest module (ie, a flat, buildingless module) on the top. That way (...) (23 years ago, 11-Jan-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Train 3 Height and Width
|
|
(...) My problem is that all but one of my modules contain 2 story + buildings, and they are almost all located on the side of a module.... I was figuring it out, and I do believe that it is possible.... I just have to be absolutly sure that I drill (...) (23 years ago, 11-Jan-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Train 3 Height and Width
|
|
(...) I always do. sorry, i could not resist Chris For Real, All this "Pretend" stuff was at first funny now, just not so funny ..... (23 years ago, 14-Jan-02, to lugnet.org.ca.rtltoronto)
|
