 | | Easing back into the swing of things....
|
|
After a brief vacation from this hobby, 'cause i was busy with other things and all... So I'm slowly getting back into it--balancing my appreciation for the brick with, well, other stuff... So with much further ado, here's me messing up a 2x4 red (...) (18 years ago, 18-Oct-06, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Easing back into the swing of things....
|
|
(...) Is it a reed switch? (...) 5 minute epoxy. Much easier to control that hot melt glue. I just helped my daughter make a nature collage, and there were hot melt glue string everywhere... It was like we had been attacked my giant spiders or (...) (18 years ago, 18-Oct-06, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Easing back into the swing of things....
|
|
(...) It looks like one. Does it need to run lengthwise in the track bed our could it run width wise. I'm just thinking you could probably hollow out a couple of plates and hide the sensor bulb completely. (...) While I don't have a better (...) (18 years ago, 19-Oct-06, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Easing back into the swing of things....
|
|
(...) It is--two metal leaves inside a vacuum (supposedly) (...) I'm finding that the sensor doesn't react to the magnet until the magnet gets close to eitehr end--so the sensor has to be pretty much centered between the rails for the magnet to pass (...) (18 years ago, 19-Oct-06, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Easing back into the swing of things....
|
|
(...) Try milliput. It is available at most hobby stores... (URL) A> (18 years ago, 19-Oct-06, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Easing back into the swing of things....
|
|
(...) Balance is good. Which is why I just spent the evening watching "Shall We Dance" with my wife. Dang, I've got to learn more than just west coast swing and a poor Waltz... (...) I really liked this one, especially because it turns out I can (...) (18 years ago, 20-Oct-06, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Easing back into the swing of things....
|
|
(...) light sensors--and the big 'n bulky bit as well... (...) Thanks for the info! Dave K (18 years ago, 20-Oct-06, to lugnet.org.ca.rtltoronto)
|
