 | | Re: Show prep on Jan 13 (was Re: SuperTrain 2001 - I'll be there) —John Koob
|
| | | Michel Magnan wrote in message ... (...) 12 seemed just enough for the last layout. For future layouts, I'd say we'd need somewhere between 16-24. (...) Yes, it was a bit short, but if you have one rope and make it taller, then small folks will (...) (24 years ago, 30-Dec-00, to lugnet.org.ca.nalug)
|
| | | |
| | | | | Re: Show prep on Jan 13 (was Re: SuperTrain 2001 - I'll be there) —Steve Chapple
|
| | | | | (...) I'm estimating 16 at this point, but the more the better. (...) Good idea - rope isn't very expensive. My Uncle has a small drill press for making the holes. SRC StRuCtures (24 years ago, 31-Dec-00, to lugnet.org.ca.nalug)
|
| | | | | |
| | | | | | | Re: Show prep on Jan 13 (was Re: SuperTrain 2001 - I'll be there) —Michel Magnan
|
| | | | | | Will yoiu be able to bring the drill press to James place? Do you need a 3/8 inch drill bit? Michel (...) (24 years ago, 31-Dec-00, to lugnet.org.ca.nalug)
|
| | | | | | |
| | | | | | | | Re: Show prep on Jan 13 (was Re: SuperTrain 2001 - I'll be there) —Steve Chapple
|
| | | | | | (...) I believe it is a counter-top model, yes. (Should be OK for bits) SRC (24 years ago, 1-Jan-01, to lugnet.org.ca.nalug)
|
| | | | | | |
| | | | | Re: Show prep on Jan 13 (was Re: SuperTrain 2001 - I'll be there) —Michel Magnan
|
| | | | I forgot to mention that we could have almost used 14 for GETS 2000, remember we butted one end up against the other train display, so we didn't need a barrier on that side. I had drilled two holes in the pipes, one 6 inches below the other, I (...) (24 years ago, 31-Dec-00, to lugnet.org.ca.nalug)
|
| | | | |
