Subject:
|
Re: Glued Minifigs
|
Newsgroups:
|
lugnet.general
|
Date:
|
Tue, 20 Jul 1999 03:04:26 GMT
|
Viewed:
|
684 times
|
| |
|
|
In lugnet.general, Greg Majewski writes:
> must have just been a little less stronger than, say, cement. (2) After
> destroying two fingernails and drawing blood, I managed to pull a visor off of
> one of the hemlets, and saw to my horror that there was yellow ABS from the
> helmet stuck to the visor. It almost appeared that the visor was melted to the
> helmet, but I did see a trace of glue and managed to scrape it off. I am
It sounds as if you are out of luck. The symptoms you describe suggest that
the glue used was meant primarily for plastic models. It bonds the parts
together by causing a chemical reaction that melts a bit of the plastic that it
is touching and causes it to merge together to effectively make one piece.
Once glued this way, stuff stays glued unless you are willing to damage one or
both parts to separate them.
> thinking of soaking the minifigs in an acid for a day or four, but I don't know
> what will work. Will vinegar or something to that extent be too strong and take
> the prining off of the minifigs? Who has had experience with this sort of
> madness?
Generally speaking, anything that's going to be strong enough to work on any
glue stronger than Elmer's White is going to wipe out the paint long before it
touches the glue.
Paul
|
|
Message is in Reply To:
 | | Glued Minifigs
|
| Hello, I just received a winning from an auction, and I must say that I am slightly (1) annoyed. The minifigs that came with the set were all glued together! After trying vainly to pull apart the minifigs, I realized that the glue involved must have (...) (25 years ago, 20-Jul-99, to lugnet.general)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
