Subject:
|
Re: How to rotate a part in LDD (Mac)?
|
Newsgroups:
|
lugnet.general
|
Date:
|
Fri, 26 Aug 2005 14:55:32 GMT
|
Viewed:
|
1035 times
|
| |
|
|
In lugnet.general, Christopher Masi wrote:
| |
However, I am going to be a bit annoying here (no surprise really). This
clinging-part thing is a bad metaphor because the “page up” and “page
down” keys don’t work on the clinging part; they only work on a placed
part. Really, LDD should choose a metaphor and stick with it. Either
move the placed part or the clinging part, but don’t switch from rule to
rule depending on how the part is to be moved.
|
Well, there’s no reason they couldn’t have it both ways; add keys to move the
pieces in X and Z after it’s placed (in addition to the existing Y movement),
and also to rotate it. Then you could move/rotate the piece while it’s clinging
to the mouse, and also nudge it incrementally after it’s placed.
Best,
– Joe
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: How to rotate a part in LDD (Mac)?
|
| (...) Thanks for the answer Eric and thanks for asking the question Joe. However, I am going to be a bit annoying here (no surprise really). This clinging-part thing is a bad metaphor because the "page up" and "page down" keys don't work on the (...) (19 years ago, 26-Aug-05, to lugnet.general)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
