Subject:
|
Re: How to rotate a part in LDD (Mac)?
|
Newsgroups:
|
lugnet.general
|
Date:
|
Thu, 25 Aug 2005 22:38:50 GMT
|
Viewed:
|
858 times
|
| |
|
|
In lugnet.general, Joe Strout wrote:
> The pop-up tip says that you can rotate the selected part by using the arrow
> keys. But the arrow keys don't do a darn thing for me. Has anyone else
> managed to rotate a part in LDD? Is this just a bug with the new Mac
> version, perhaps?
>
> Thanks,¬
> Joe
I don't know about MAC, but in LDD for PC (I assume is the same principle) once
the part is selected, meaning you click with the arrow from the parts pallet,
and when the part is shaded then you can rotate the part with the arrow keys.
Be sure you have the part selected and it is shaded while the arrow (cursor) is
holding the part. Don't place it, rotate while it is selected.
e
|
|
Message has 1 Reply:
 | | Re: How to rotate a part in LDD (Mac)?
|
| (...) Oh! That's the problem. You have to do this while the part is still clinging to the mouse cursor. This whole clinging-part mode is alien to us Mac users — modes in general are considered evil here, and I keep trying to grab a piece and drag it (...) (19 years ago, 25-Aug-05, to lugnet.general, FTX)
|
Message is in Reply To:
| | How to rotate a part in LDD (Mac)?
|
| The pop-up tip says that you can rotate the selected part by using the arrow keys. But the arrow keys don't do a darn thing for me. Has anyone else managed to rotate a part in LDD? Is this just a bug with the new Mac version, perhaps? Thanks, Joe (19 years ago, 25-Aug-05, to lugnet.general, FTX)
|
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
