| |
"Carl Watson" <cbccwats@pop.ihug.com.au> writes:
> "Bill Ward" <bill@wards.net> wrote in message news:GIyB5q.F3E@lugnet.com...
> > In lugnet.town, Carl Watson writes:
> > > http://www.brickshelf.com/cgi-bin/gallery.cgi?f=6257
> >
> > Very cool! I like that a lot. Very simple and clever. How is it • attached at
> > the bottom? Also, is it attached to the wall on the side?
>
> http://www.brickshelf.com/gallery/cbccwats/MOC/slidedoor/comp_02.jpg
> It was not attached at the bottom or sides, & wasn't very strong. It sat on
> top of tiles.
> If I were to build another I would put some type of pin underneath that slid
> along in a groove.
Still, it's very innovative. Thanks for the update.
> To attach it at the sides would be difficult as it turns 90 degrees & moves
> two studs in/out.
Good point. However, it wouldn't need to do so. You could put a
plate hinge on the top of the door and have it simply hinge to the
side. The other "runner" on the top would be on the extreme end
rather than in the middle of the panel.
> Sorry about the lateness of my reply
No problem. I appreciate the clarification.
--Bill.
--
William R Ward bill@wards.net http://www.wards.net/~bill/
-----------------------------------------------------------------------------
AMAZING BUT TRUE: There is so much sand in northern Africa that if it were
spread out it would completely cover the Sahara Desert!
|
|
Message is in Reply To:
 | | Re: New Pics for Sliding door MOC.
|
| "Bill Ward" <bill@wards.net> wrote in message news:GIyB5q.F3E@lugnet.com... (...) attached at (...) Hi Bill (URL) was not attached at the bottom or sides, & wasn't very strong. It sat on top of tiles. If I were to build another I would put some (...) (22 years ago, 16-Jul-02, to lugnet.town, lugnet.build, lugnet.general)
|
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
