Subject:
|
Re: New parts in UCS Tie Fighter?
|
Newsgroups:
|
lugnet.general
|
Date:
|
Thu, 11 May 2000 20:41:06 GMT
|
Viewed:
|
1640 times
|
| |
|
|
In lugnet.general, Tom Stangl writes:
> "Fredrik Glöckner" wrote:
>
> > Tom Stangl <toms@netscape.com> writes:
> >
> > > I'm opening the bags on the UCS Tie Fighter, and found the following new
> > > pieces, I think:
> > >
> > > a blue 1x4 brick with 4 studs on top as usual, but it also has 4 studs on
> > > one side
> >
> > Are the studs recessed, like on the 1x1 headlight brick? Any holes on
> > the opposite side?
>
> Not recessed, no holes on the other side - just studs sticking out of one • side -
> Technic style "hollow" studs that go into the interior of the brick (on the
> wings, 2 of the holes have shovels shoved into them).
This part is also in the UCS X-Wing. I thought it was cool when I saw it.
There were a couple other pieces that I thought were new also.
>
> > > A grey 4x4 hollow technic brick - 4x4 with 2x2 hole in the middle, 3
> > > technic holes on 2 sides, 1 hole on the other 2 sides
> >
> > Does this mean that the outer pair of holes on the side with three
> > holes don't go all the way through the 4x4 brick?
>
> All holes go all the way through - it's a 4x4 brick with a 2x2 cutout in the
> middle - picture 2 1x4 beams and 2 1x2 beams arranged in a square. However,
> while the outer 2 holes on the 3-hole side go all the way through, you can • only
> fit a single peg length through them.
..but the X-Wing didn't have this one.. sounds interesting
-mark
|
|
Message is in Reply To:
 | | Re: New parts in UCS Tie Fighter?
|
| (...) Not recessed, no holes on the other side - just studs sticking out of one side - Technic style "hollow" studs that go into the interior of the brick (on the wings, 2 of the holes have shovels shoved into them). (...) All holes go all the way (...) (26 years ago, 11-May-00, to lugnet.general)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
